Copyright © 2019 Shellrus LLC. All rights reserved.

Website version 10.1

REV 12/12/2019

Shellrus 3D Pro

 

In 2014, Apple started to use 2.5D curved edges on the iPhone.

 

The curved part on the screen is the biggest issue. Traditional OCA glue is a clear, thin sheet that has adhesives on both sides, and it is wildly used in screen protector production. However, OCA glue only works on a flat surface, and it chips on curves. So, OCA screen protectors have two solutions:

1. Cover the flat part of the screen only.

2. Use heat curved glass, cover the flat part with OCA glue, and use bezel to hide uncovered edge. 

Both of the solutions have the same issue: only part of the screen is glued. Furthermore, solution one makes it uncomfortable when you swipe across the edges; solution two is too thick, and the bezel will reduce the display area.

 

3D Pro is the best solution so far. 

The heat-curved glass fits the original screen 100%. You won’t feel the screen protector at all. The most exciting part is our Jelly Glue. Our specially formulated Jelly Glue is liquid, and it solidifies under ultraviolet light. So, don’t forget to avoid sunlight during installation.

 

Since Jelly Glue is liquid, it goes into every gap between the 3D pro glass and the screen. Jelly Glue has similar properties to silicon glue after solidification, which provides extra cushioning when your screen faces impact. Our Jelly Glue also fills in scratches on your screen, making them invisible. Jelly Glue is safe to use, and its odor will be gone after solidification. It can be washed away completely with soap.